Shacman X6000 fault codes — EBS & WP13

Weichai WP12/WP13 — classic P/SPN (rail, boost, CKP). Separately: EBS (wheel sensors, modulators), network U100601 and ECU loss. Without naming the system, “just 26153” can send you to the wrong module.

Engines: WP12, WP13.

Frequent codes

• EBS 26153 / SPN 26153 — often wheel speed sensor (field — wheel 3) or harness;
• EBS 26409 — modulator / CAN to EBS;
• U100601 — CAN loss;
• engine: P0087, P0299, P0335, U0100 as on any WP13;

• P0087 — low common-rail pressure
• P0088 — high common-rail pressure
• P1011 — HP pump metering valve fault
• P0093 — large fuel leak / CAN trap — FMI needed
• P0193 — rail pressure sensor high signal
• P0299 — boost below target
• P2263 — turbo / boost performance
• P2563 — VGT position sensor
• P0335 — crankshaft sensor no signal
• P0340 — camshaft sensor — FMI needed
• P0401 — EGR insufficient flow
• U0100 — lost communication with engine ECU
• U0101 — lost communication with TCM
• U0155 — lost communication with cluster
• P0562 — system voltage low
• P0201 — cylinder 1 injector circuit
• P0480 — fan control circuit
• P0217 — engine overheat
• P0116 — water in fuel (Weichai table)
• P2509 — intermittent ECM power
• SPN 2898 — without FMI — not a diagnosis
• SPN 729 — intake heater — FMI needed

Field notes

In the ChinaDiag form set Shacman, X6000, year and the code as on the scanner (with FMI if present).

Fault code table

Table for “Shacman X6000 fault codes”: WP engine + EBS/CAN. Field example: SPN 26153 / FMI 0 — wheel speed sensor 3.

Full step-by-step — enter the code on the home page. If a card exists, click the code.

How to use

home page — Shacman, X6000. Fault codes.

Look up the code in the service